Plasma cutting machine is not really complicated. You need to pay attention to these points:

1.With the air compressor flow should not be less than 0.3 m3 / min, the working range of 0.4 ~ 0.8 MPa.

2.The arc cutting, should be started arc, the edge of the work must begin from the middle of workpiece in cutting, should first open a small hole drilling, begin from the edge of the hole arc again. Open the power switch, let the air flow for a few minutes,to remove condensation of vapor in the cutting torch, start cutting, the cutting torch nozzle to contact artifacts (such as dispute contact cutting torch, nozzle to leave artifacts 3 ~ 5 mm), press the cutting torch switch, automatic plasma arc ignition, the official start of the cutting. Cutting process, the cutting speed to ensure cutting wear artifacts, cannot too fast not only cut through artifacts,

may cause the slag burning nozzle, slowly will lead to the nozzle temperature is too high, reduce the service life of the nozzle, and the slot width, residue increase, and may be the cause of fault arc. Stop cutting, to loosen the cutting torch switch first, and then will leave the workpiece cutting torch.

3.Always check the motor, nozzles, such as a serious loss should be replaced to avoid affecting the cutting thickness and width of the center electrode alloy wire or can not consume more than 2.0mm when the arc, the electrode can reverse installation or update. Cutting machine high output voltage, the power must be turned off when you replace the electrode or the nozzle assembly and wear protective gloves, electrodes, nozzles vertically upwards and tighten using twenty-three minutes before tightening again.

Kasry CNC Technology Co., Ltd. specializing in the production and sales of CNCcutting machine, intersection Cutting,CNC flame cutting machines,CNCplasmacuttingmachines, welding machines, industrial robots, laser cutting machine, automatic welding equipment,cutting and welding equipment,